高人请进，M65刷机后不开机，x65flasher和v_klay3.2不联机

wang526

M65刷机后不开机，x65flasher和v_klay3.2不联机，有备份，可是如何刷回去。

用x65PapuaUtilsV111b.exe算出BKEY后不能写入，进Normal mode和Service mode只显示如下信息


Boot in "Service mode"...
Press RED key (Power ON)!
Auto Ignition...
Transfer boot...
Boot in "Service mode" Ok
Awaiting Power On phone...
Phone was switched off on error:
EXIT: 0000:DA7E
FILE:
hw_det
CPSR: 60000010
CepId: 40F1
ExitString:
Invalid HW

Boot in "Normal mode"...
Press RED key (Power ON)!
Auto Ignition...
No answer to boot load!
Check port number, cable, phone, mode!
Boot in "Normal mode"...
Press RED key (Power ON)!
Auto Ignition...
Transfer boot...
Boot in "Normal mode" Ok
Awaiting Power On phone...
Phone was switched off on error:
EXIT: 0000:DA7E
FILE:
hw_det
CPSR: 60000010
CepId: 40F1
ExitString:
Invalid HW


刷克服包也不行


请高人指点

441818088

不懂，帮顶了，请高人来指点吧

wang526

高人呀？？？？我======

wang526

晕，没人呀

wangli19860418

在x65PapuaUtilsV111b.exe的刷机功能里，点重新算各项码！然后点刷机的时候短按关机键！！

wang526

不行呀，显示如下


BOOT is loaded...
Pause 2 sec...
Getting Information...
FlashID: 0089,880D (32Mb)
BCORE Cleared!
OTP ESN: 4ACBA12C
OTP IMEI: 353669004441775
Bcore R65 series found
Reading of segment BCORE...
Search of a segment EELITE...
Search of a segments EEFULL...
Find blocks: 52,76,5008,5009,5077,5121,5122,5123
In total EEP blocks: 235
SKEY in block 5122 = "X" 48391804
Replacement of blocks EEPROM in the buffer ...
EEPROM: Block 76 does not require replacement.
EEPROM: Block 52 replaced.
EEPROM: Block 5122 does not require replacement.
EEPROM: Block 5123 does not require replacement.
EEPROM: Block 5009 does not require replacement.
EEPROM: Block 5008 replaced.
EEPROM: Block 5077 replaced.
EEPROM: Block 5121 replaced.
New Master codes:
*#0000*12345678#
*#0001*12345678#
*#0002*12345678#
*#0003*12345678#
*#0004*12345678#
*#0005*12345678#
BCORE "Cleared", recalculation impossible
Record of the changed blocks in phone...
Write down EEPROM segments...
EEPROM segments write down.
Boot released. Everything is closed.!

4758608

关机刷客服包.升客服包的软件界面有两个"SKIP"按钮,在前面打钩,按"STAR"开始刷机,须短按开机按钮,多试几次.成功的话,就开始升级了.也可以上西客站或凤凰涅磐斑竹的新手刷机教程.